特级免费毛片-特级毛片在线观看-特级毛片在线-特级毛片永久久免费观看-特级毛片一级美国黑人-特级毛片网站

After line 1: before the fast online using the new line and the old line will be tied to the guide pin, manual pull after restart.

2 in the automatic working state personnel body can not be placed in the framework of the material groove and the upper material in the middle of the area, otherwise it will happen the danger of the hand.

The path of the 3 line to confirm the porcelain eye before starting, after anti jumper, flywheel tension device must cross the line in a circle. Open the unloading switch can be easily manual clip line, starting before the start must be closed, otherwise the clip will not be reliable.

4 if there is a power failure or emergency stop, please reset after the clip line to restart.

5 please confirm the power and compressed air in place, after the manual reset to start.

6 the check range: the tension device is normal, the line of the path is smooth, whether the skeleton is complete, the height of the guide is appropriate, whether the line can be used up.

7 the placement of the skeleton must be in place, such as the occurrence of the skeleton is not in place to produce damage, please press the pause button, and confirm all the skeleton in place and then press the start button. The skeleton of the pin skew need to be corrected, the foot is not placed.

8 tension adjustment principle is set at the foot of the low, high, to avoid the subsequent solder wire. Can be adjusted according to the actual situation.

9 for the line, please use the hand to touch the line on the barrel along whether there is a foreign body burr, will interfere with the line of the line, causing the line.

10 booking button is very skilled use, the full automatic button must ensure that each cycle has a full skeleton to put time and complete grasp. The two buttons are advised not to use as much as possible.

Previous：Problems and solving methods of pressure paper on winding machine

Next：How to carry over speed test to the automatic winding machine